Sukam Sukam Fusion CUPS Series 3.5 KVA / 48 V UPS & Inverter
Fusion Series Pure Sine Wave Commercial UPS Micro Controller Based PWM Technology using MOSFET, 3500 VA Capacity,High Temperature Warning and Over Temperature Shutdown
Click to Enlarge image(s)

The world’s most advanced commercial UPS Based on the world’s most advanced DSP Sine Wave Technology, Fusion Pure Sine Wave UPS is the World's most advanced Commercial UPS. The power it supplies is actually purer than the power supplied from the mains. This is clearly evident, as appliances don't make any irritating, humming sound as they do on normal UPS available in the market. Today, with expensive equipment like computers, water motor pumps, microwave ovens and air conditioners being used extensively, an ordinary UPS cannot supply the right kind of power to run these everyday utilities. Here the Fusion gives the consumer the additional advantage of being able to power all their electronic appliances, whenever required.

  • Bypass Feature (24x7 Service): In case of maintenance of the battery/failure of CUPS or during the servicing of the CUPS, the customer can directly switch to the Mains by a simple twist of a switch, and will not need any electrician to remove any wires from the CUPS
  • Wide UPS Mode/UPS Mode: A switch at the back of the CUPS allows you to select UPS mode or W-UPS mode depending on your requirement. In UPS mode the input power supply range is limited so you can use this mode to run your computer only. While in W-UPS mode the range of input power supply is wide so as to allow you to run heavy appliances like Air Conditioner, Refrigerator etc.

If you need futher guidance regarding various things to consider while purchasing UPS & Inverter, please read our Conzumr Guide

Out of Stock

Check best selling models @
Highlights
Capacity 3500 VA
Series # Fusion Series
Available on Conzumr Since April 2017
Buy Now Fusion CUPS Series 3.5 KVA / 48 V
Home Shop 18 ₹ 20093 33% off
Sukam ₹ 29990
Refreshed 1 month ago

General Specification
Technology Micro Controller Based PWM Technology using MOSFETs.
Charger Current 13A+_1.0 A or 16A+_1.0A
Capacity 3500 VA
Capacity Battery 48 V
Battery Features
Battery Hups
Efficiency (on battery mode) >88%
Low Battery Cutout 10.5V+_0.2V
Recommended Battery 12V(SMF/Flooded)
Max. Battery Boost Level 14.3V ± 0.2V
Max. Battery Float Level 13.7V ± 0.2V
Battery Recharge Time FLC basedSCR charging with soft start over full range of mains 140V to 285V +_10V
Design
DSP Based PWM technology using MOSFET Yes

DSP is one of the most powerful and advanced technologies which is used for high speed processing applications. This helps in saving loss of power, which happens during the process of power generation by a normal Commercial UPS.

Waveform Type Pure Sinewave Output

Pure Sine Wave is the purest and is 100% clean, regulated, and completely stable and distortion free power output, which is absolutely safe for running complex appliances without humming & irritating sound.

Instant Switch Over Yes

In case of power failure, the process of switching over the battery mode is of few milliseconds hence the power supplied to the connected appliances, like computer is not interrupted, as a result of which the system does not reboot.

Protection for your Appliances Yes

A feature, which will automatically switch on to the Battery mode in case there is extreme high or low voltage supplied from the mains, which protects your valuable equipment.

Constant Supply of Power Yes

During power failure, the voltage supplied by CUPS will not differ with the increase or decrease in the load, hence delivering electricity consistently through CUPS. The voltage & frequency at the battery mode will be consistent and will not be affected by increase or decrease in the load.

Input & Output
Output Voltage on Mains Mode 220V ± 10V
Output frequency on UPS Mode 50.0 Hz +_ 0.3 Hz
Voltage Range NW UPS Mode
Main AC Low Cut 140+_10V
Main AC Low Cut Recovery 150+_10V
Main AC High Cut 270+_10V
Main AC High Cut Recovery 260+_10V
Voltage Range NW UPS Mode 140V-260V+_10V

Voltage Range NW UPS Mode - Narrow-Wide range is the range of input voltage for which power inverter will work on line mode (external power) and then switch to backup mode. For example, you have got a power inverter that has got ‘narrow range’ of 170 V to 250 V, it won’t switch over to batteries backup if voltage is higher than 170 V and lower than 250 V. On the other hands, if ‘wide range’ is selected which is supposedly designed for 110 V to 260 V, the power inverter will not switch to backup mode as long as external power is available and voltage is higher than 110 V and lower than 260 V.

Voltage Range WW UPS Mode
Main AC High Cut 260 ±10V
Main AC High Cut Recovery 250 ± 10V
Main AC Low Cut 190 ± 10V
Main AC Low Cut Recovery 180 ± 10V
Voltage Range WW UPS Mode 180 -260 ±10 V
Dimensions
Weight 30.5 kg
Width 395 mm
Length 245 mm
Height 355 mm